Ht-omega-claro-halo-sound op amp replacement

HT OMEGA CLARO HALO SOUND OP AMP REPLACEMENT PRO

It can work out very well, or be distracting, depending on what you're listening to. You can mess around with the speaker shifter (which will grey out HF if you do, so click it back when done), in order to expand the soundstage, if you like. On the right hand side, click HF and GX (under the DSP settings), so that they are highlighted in green. I'm not positive what you need the Analog Out to be set to, for your headphones, as I use a stereo jack, but the 5.1 you have it set to seems correct. Now, go into your Xonar Audio Center, and set it to 6 channels (which you did already), and PCM 44.1khz.

I honestly never looked in to 5.1 headphones, so my lowly Denons only have one speaker on each side. If you get a lot of distortion after, unckeck the full-range speaker boxes except subwoofer. Now in the sound tab highlight the Xonar again, select Configure, set it to 5.1 Surround, hit next, check all of the optional speaker boxes, click next, under full-range speakers make sure all boxes are checked, and click Finish. Go into your control panel, Hardware and Sound, Sound, highlight the device in playback, click properties, pick the advanced tab, adjust it to 24 bit, 44100 hz, both boxes below checked. I'm assuming you're using Win7, by the way. I'm not sure I'll be able to help as much, in that case, as I don't have experience with headphones that use multiple inputs. Its a 5.1 headset with the rear, front, center/subwoofer and microphone ports to plug into the sound card, im looking for Mixed settings and its ok im new to this stuff iv'e always used onboard :p That isn't a realtek thing, it is the HD audio spec that sets that rate. If the source is 44,1Khz or 192Khz then there is some slight, very slight bit altering to make up for the difference because it has to sample the bus at different intervals to keep the clock correct. The bus between the chip and the host cpu is natively 48Khz so if the source uses that then it is bit perfect. Here is how the realtek chips map digital, notice the difference in analog and how it goes through lots of filters, etc. 01% difference, but knowing how picky some people are they will claim they can hear that

Just make sure you do not enable the eq, or any of the processing features as that will cause the audio to take a path through the chip and be altered vs going straight out the port like the source.

HT OMEGA CLARO HALO SOUND OP AMP REPLACEMENT PRO

I am someone who used to use dedicated cards from M-audio, cirrus logic, Envy pro cards but with the way the current chips handled digital out there is no need. Connect to external amp with a DAC and your set. They send the stream straight out the port unmodified. The realtek chips do not do anything with the audio when you set them to spdif/optical out.

Hi end audio would be any recent motherboard with a spdif out port.

Ht-omega-claro-halo-sound op amp replacement